Manual

Chapter 3 FiberChekPRO Software
FiberChekPRO controls
P5000i Digital Analysis Probe Getting Started Guide
August 2021 ZP-PKG-0574, R500 Page 11
2 Install Inspection Tip on Probe
Select the appropriate inspection tip that corresponds to the connector type and
side being inspected and attach it to the probe.
3 Select Profile
From the preconfigured PROFILE settings drop-down list, select the appropriate
pass/fail analysis profile for the connector type to be inspected.
4 Select Optical Setting
From the preconfigured OPTICAL SETTING drop-down list, select the
appropriate optical setting for the tip connected to the probe
5 Inspect
Mate the probe to the connector under test by either inserting the probe with tip
into a bulkhead adapter or inserting a patch cord into the tip.
6 Focus the Fiber End Face Image On Screen
Adjust the focus of the fiber end face image on the computer screen by turning the
Focus Control on the microscope.
7 Test
Press the QuickCapture button on the probe or click the Test button from the
FiberChekPRO tool bar to run the analysis.
FiberChekPRO controls
The following sections describe the FiberChekPRO controls.
Live View controls
Figure 3 shows the Live View.
Figure 3 Live View
p5000i-GettingStarted.book Page 11 Tuesday, August 3, 2021 1:15 PM