User's Manual

Chapter 6 DSL Testing

Specifying test settings

SmartClass TPS User’s Guide

56 22035456, Rev 001 May 2014

3 Select PTM Operation and then specify the settings. The PTM settings are available if your

unit has a Broadcom modem. It is greyed out if you specified ATM transport mode. The

following table describes the settings.

4 Specify the Mac Addr. Mode —

factory default or user defined.

The WAN settings are specified.

Specifying LAN settings

If the modem operation mode is Router, the LAN Setup is available

To specify LAN settings

1 From the Network menu, select LAN Setup, and then specify the settings. The following table

describes the settings.

Setting Description

Data Mode Select the network type.

– None turns the data layer off

– IPoE is IP over Ethernet

– PPPoE is PPP over Ethernet

IP Mode Select either Static or Dynamic (DHCP) if using IPoE.

IP Addr. If the IP Mode is Static, enter the IP address that the

tester will use.

IP Netmask If the IP Mode is Static, enter the net mask address.

Gateway If the IP Mode is Static, enter the gateway address.

DNS Server If the IP Mode is Static enter the address of the DNS

server.

to automatically or manually login. If set to manual, the

data synchronization will not occur until you login.

PPP Username Enter a valid user name.

This must be a valid user account with an ISP.

PPP Password Enter the user password.

This must be a valid password that matches the user

name above. Passwords are often case-sensitive.

Setting Description

Server IP

Enter the tester’s LAN server IP address.

Netmask Enter the LAN net mask address.

LAN DHCP Server Enable or disable the tester’s DHCP server.

You should enable the DHCP server when the cus-

tomer’s CPE is configured to receive an IP address

automatically.

DHCP Start If DHCP Server is enabled, enter the starting IP

address for the tester’s DHCP server.

DHCP End If DHCP Server is enabled, enter the ending IP

address for the tester’s DHCP server.