User's Manual

Chapter 6 DSL Testing
Specifying test settings
SmartClass TPS User’s Guide
May 2014 22035456, Rev 001 55
2 Select ATM Operation and then specify the settings. This selection is greyed out if you speci-
fied PTM transport mode on the DSL settings menu (Broadcom only).
The following table describes the settings.
Setting Description
Data Mode Select the network type. (only in Router mode)
None turns the data layer off
– IPoE is IP over Ethernet
– PPPoE is PPP over Ethernet
– IPoA is IP over ATM
– PPPoA is PPP over ATM
IP Mode Select either Static or Dynamic (DHCP).
IP Addr. If the IP Mode is Static, enter the IP address that the
tester will use.
Netmask If the IP Mode is Static, enter the net mask address.
Gateway If the IP Mode is Static, enter the gateway address.
DNS Server If the IP Mode is Static enter the address of the DNS
server.
Login Mode Only appears if IP mode is Dynamic, specify whether
to automatically or manually login. If set to manual, the
data synchronization will not occur until you login.
WAN VPI / VCI Specifies the VPI and VCI for the customer-facing port
on the DSLAM.
Encapsulation Select LCC-SNAP or VC-MUX.
PPP Authentication
(TI modem only)
If the Data Mode is PPPoE or PPPoA, select the
authentication mode
– Auto means that the SmartClass Triple Play Ser-
vices picks the mode that matches the far end
mode
– CHAP is Challenge Handshake Authentication
Protocol
– PAP is Password Authentication Protocol
PPP Username Enter a valid user name.
This must be a valid user account with an ISP.
PPP Password Enter the user password.
This must be a valid password that matches the user
name above. Passwords are often case-sensitive.
PPP Use Provider
(TI modem only)
Select Yes or No.
This option indicates whether to append the user name
with the service provider domain name (for example,
earthlink.net). Select Yes only if user names for the
ISP must include the domain name as part of the user
name. This setting automatically appends the @ sign
for you.
PPP Provider Enter the provider name.
This is required if you selected Yes for “Use Provider.”