User's Manual

Chapter 6 DSL Testing
Specifying test settings
SmartClass TPS User’s Guide
52 22035456, Rev 001 May 2014
Specifying DSL settings
The settings vary depending on whether testing on a single line or bonded.
Specifying DSL (single line) settings
To specify DSL test settings
1 From the ADSL/VDSL menu, select DSL.
The DSL Summary results menu appears.
Press the asterisk (*) to view the Setup menu.
2 Select xDSL Standard and then choose ADSL, VDSL, Auto, or Incremental. Auto will query
the DSLAM for the standard. Incremental will cycle through a period of broadcast sequences
to the DSLAM, going from VDSL to ADSL and then repeating.
3 If you specified ADSL as the DSL standard, do the following:
a Select Operation and then select Over POTS or Over ISDN.
b Specify the ADSL Modulation standard in use.
– Auto will revert to ADSL2 if the line doesn’t support ADSL2+ or revert to G.DMT if line
doesn’t support ADSL2. Select Auto if using Annex M.
– Annex M
–G.DMT
– G.Lite (only available if Operation is Over POTS)
–ADSL2
– ADSL2+
– T1.413 (only available if Operation is Over POTS)
c Select Transport Mode and then choose the transport.
ATM specifies Asynchronous Transfer Mode. PTM specifies Packet Transfer Mode. Auto will
query the DSLAM for the transport mode.
4 If you specified VDSL as the DSL standard, do the following:
a Select Operation and then select Over POTS or Over ISDN.
b Specify the VDSL Profile profile (for example, 8a, 12b, and so on).
– Auto will query the DSLAM for the profile.
–8a
–8b
–8c
–8d
–12a
–12b
–17a
–30a
NOTE:
You may not see all of the settings above. The available selections vary,
depending on the configuration and installed options.