User's Manual

Chapter 5 Ethernet TE Testing

Connecting to the line

SmartClass TPS User’s Guide

44 22035456, Rev 001 May 2014

If you are connecting over WiFi

You are finished specifying the network setup.

Connecting to the line

After specifying the test settings, you can connect to the line.

To connect to the line

1 Connect one end of an Ethernet cable to the Ethernet jack on the right side of the unit.

2 Connect the other end of the cable to an Ethernet jack.

Global Addr. If using IPv6oE and the IPv6 Mode is Manual, specify the global IPv6

address.

Local Address Mode If the IPv6 Mode is Manual, specify whether the local address mode is

automatic or manual.

IPv6 Local Address If the IPv6 Mode is Manual, and the Local Address Mode is Manual, specify

the local address.

Subnet Prefix Length If you selected Manual IPv6 mode, specify the length of the subnet prefix,

from 0 to 128.

IPv6 Gateway If using IPv6oE and the IPv6 Mode is Manual, enter the gateway address.

DNS Mode If you selected Stateless IPv6 Mode, specify the DNS Mode: Manual or

DHCPv6. This determines whether DHCP will be used to get the DNS

server address.

PPP Username Enter a valid user name.

This must be a valid user account with an ISP.

PPP Password Enter the user password.

This must be a valid password that matches the user name above. Pass-

words are often case-sensitive.

PPP Use Provider Select Yes or No.

This option indicates whether to append the user name with the service

provider domain name (for example, earthlink.net). Select Yes only if user

names for the ISP must include the domain name as part of the user name.

This setting automatically appends the @ sign for you.

PPP Provider Enter the provider name.

This is required if you selected Yes for “Use Provider.”

PPP Use Service

Name

Select Yes or No to whether to use the Service Name.

PPP Service Name Enter the Service Name.

This is required if you selected Yes for “Use Service.”

data synchronization will not occur until you login.

Setting Description