User's Manual
Chapter 4 Using the SmartClass TPS with a mobile device
Viewing video on a mobile device
SmartClass TPS User’s Guide
May 2014 22035456, Rev 001 39
After the test finishes, the results are displayed.
For more information on testing with SmartIDs, see Chapter 10 “SmartID Testing”.
Viewing video on a mobile device
SmartClass TPS provides a means to display video ouput from a set-top box. This is useful for
installations where the customer’s television is not yet accessible but the video service must be veri-
fied.This test uses a device such as the Dazzle
®
to view the video.
To view video on the mobile device
1 If you haven’t already done so, launch the SCTPS app.
2 Connect the Dazzle device to the RGB video outputs on the STB.
3 Connect the output side (USB) of the Dazzle device to the USB port of the SmartClass TPS.
4 Configure the SmartClass TPS as a Wi-Fi access point and connect the mobile device to the
SmartClass TPS. See “Communicating with a mobile device” on page 23.
5 From the mobile device’s Controller screen, select Video Continuity Check through the
Dazzle.
The MPEG stream from the Dazzle USB output is streamed through the SmartClass TPS to
the iPad.
6 View the video in the mobile device application.