User's Manual

Chapter 4 Using the SmartClass TPS with a mobile device
Controlling the device interface
SmartClass TPS User’s Guide
May 2014 22035456, Rev 001 37
Controlling the device interface
From the mobile device (such as an iPad), you can run tests on the <product name>.
To control the device interface
– On the Controller page select Device Interface.
The SmartClass TPS interface appears on the mobile device. You can now control the device
as if you were pressing the actual buttons on the device.
You can run most of the tests that are available on the SmartClass TPS. See Table 8 “Remote
access support” on page 25.
To return to the main Controller page, select the Controller button in the upper left.
Testing with SmartIDs
The mobile device app allows you to test with SmartIDs.
To test with SmartIDs
1 On the main Controller page select SmartIDs.
The <product name> goes into remote control mode and the mobile device screen displays
the Locate SmartID page.
You can now use either the instrument’s user interface or the SmartID App in the main
Controller page to run the Good Home Check.
To return to the main Controller page, select the Controller button in the upper left.
2 To locate SmartIDs, tap Start Scan
The progress bar at the top will indicate Scanning...