User's Manual

Chapter 4 Using the SmartClass TPS with a mobile device
Controlling the SmartClass with a mobile device
SmartClass TPS User’s Guide
36 22035456, Rev 001 May 2014
Controlling the SmartClass with a mobile device
Using an app on the mobile device, you can connect to a SmartClass and control the user interface.
SmartClass TPS supports mobile device applications on both iOS and Android.
To control the SmartClass with a mobile device
1 To configure the SmartClass TPS as a Wi-Fi access point for the mobile device, see “Commu-
nicating with a mobile device” on page 23.
2 Setup the mobile device to connect to the <product name>’s Wi-Fi network.
a Go to the Settings menu.
b Select Wi-Fi and find the SSID for the SmartClass that you wish to connect to.
3 On the mobile device, launch the SCTPS app.
The Controller page appears.
From this page, you can select whether to control the <product name> user interface, check video
with Dazzle, or test with SmartIDs.
Across the bottom, icons are available for:
Controller pagethe screen above, allows control of the user interface, launching a video
check, and testing with SmartIDs (see “Controlling the device interface”, “Viewing video on a
mobile device”, and “Testing with SmartIDs”)
Job Managerused to manage test results
Quick Cardsview quick cards (short documents of instructions)
Manualread the manual
Videosview instructional videos
Accessoriesview the guide for the accessories
For iOS mobile device, if you are controlling the <product name> using an iPhone instead of an
iPad, the screen will appear slightly different: the SmartID app is replaced with the Job Manager
(SmartID tests are only available on the iPad and Job Manager is not an icon at the bottom).
For Android device, the SmartClass TPS GUI is very similar to that of the iOS mobile device.