User's Manual

Chapter 3 Automated Testing
Running the OneCheck test
SmartClass TPS User’s Guide
May 2014 22035456, Rev 001 33
– DSL Setup - specify the Sync Timeout (the time to wait for synchronization to occur before
timing out), and then if needed, specify the other DSL settings as described in “Specifying
test settings” on page 49.
b Select Network Setup, and then specify the settings as described in “Specifying the
network setup” on page 42.
c Select Ping Setup, and then specify the pass/fail settings for replies lost, average ping
time, and max ping time. If needed, also specify the settings as described in “IP Ping
testing” on page 62.
d Select File Transfer Setup, and then specify the following:
– Pass/Fail thresholds for upload rate and download rate.
– FTP/HTTP Test Setup as described in step 1 of “Throughput testing” on page 64
e Select Video Setup, and then specify the following:
– Channel List - import the video channel list.
Use this menu to import the .txt file (tab delimited) that contains the channel list. It can be in
one of the following places:
the TestSetup\VideoCheck directory on the unit or on a USB stick,
the TestSetup directory on a USB stick,
or the root directory of a USB stick.
By default, the channellist.xls template is located in the root directory on the unit (/cust/
public). Copy that file, update it, save as a .txt file (tab delimited), and then import it as
mentioned above.
– IGMP Version - specify the version of IGMP signaling being used on the circuit: version 2 or
version 3.
– Concurrent video streams - specify the number of streams to test simultaneously, up to
three.
– Test duration - specify the amount of time to test each video stream. Selecting 0 seconds
will only verify that we can connect to the video stream. QoS values will not be gathered.
– QoS Thresholds - specify the thresholds as described in step 3 of “Specifying test settings”
on page 97. The pass/fail result based on these thresholds will be included in the test,
unless the test duration is zero seconds.
f Select VoIP Setup, and then specify the following:
– Number to call - On the General Setup menu, enter a phone number to dial.
– Call duration - On the General Setup menu, specify the length of time to leave the call up.
– All other settings as described in “Specifying test settings” on page 86
g Press Cancel to return to the OneCheck menu.
5 Press the # key to Start the test.
The test begins. The test may take several minutes.
As the test runs, the status and results of the test are displayed.
A check mark indicates pass; an “X” indicates fail, an exclamation point indicates a marginal
result.
The test stops automatically when complete.
For more information on the other results, see Chapter 16 “Test Results”.
6 To save a test report, press the utility (i) key and then select
Save Report or Save To Job, and
then specify the report settings such as report name, report format, technician ID, location,
and other settings as needed.