User's Manual

Chapter 2 Instrument Settings
Viewing unit revisions, options, and IDs
SmartClass TPS User’s Guide
30 22035456, Rev 001 May 2014
Viewing unit revisions, options, and IDs
The Options and Revisions screens provide the software and hardware versions and list the
installed options.
To view the installed options
1 Select System Settings from the Main Menu, and then Administration.
2 Select Options.
A list of current options appears and indicates whether the option is installed on your unit.
The unit’s unique Hardware ID number also appears on this screen. You will need this ID if you
are adding options to the unit. For more information, see “Adding options” on page 149.
To view the unit revisions
1 Select System Settings from the Main Menu, and then Administration.
2 Select Revisions.
The system software version appears.
3 To view more detailed information for a specific component, select System Information,
Modem Information, or Copper Board Information (if the copper board is installed).
This will report the hardware type and rev and the software rev of each component.
Restoring factory defaults
The following procedure describes how to reset the SmartClass Triple Play Services to factory
default settings.
To reset to factory defaults
1 Select System Settings from the Main Menu.
2 Select Restore Settings.
A confirmation menu appears.
3 Press the OK key to reset the defaults or Cancel to keep the current settings.
After resetting, the unit reboots.
NOTE:
The PHY Rev that is displayed on the Modem Information screen varies depending on which
application you are running when you entered the menu. For DSL applications, the rev is dis-
played but is different based on single line versus bonded and ADSL versus VDSL. The PHY rev
is not displayed when you are in the Copper or Ethernet TE application.
NOTE:
Restoring factory defaults will reset test application settings and system settings (such as con-
trast and language). It does NOT change or delete stored configurations or saved results.