User's Manual

Chapter 2 Instrument Settings
Managing test configurations
SmartClass TPS User’s Guide
May 2014 22035456, Rev 001 29
Managing test configurations
After you specify settings for a configuration, you can store the configuration for future use, or load
a saved configuration.
Saving test configurations
You can define and store configurations using your most common settings, and then load an
existing configuration and edit the settings as needed for your current test.
To save test configurations
1 Specify the settings for the configuration.
2 Select System Settings from the Main Menu, and then File Management.
3 Select Save Setup, and then do one of the following:
– To save as a new configuration, select New.
– To overwrite a previously saved configuration, navigate to the desired configuration file, and
then press OK.
The test configuration is stored.
Loading a configuration
After you save a configuration, you can load it at any time to run a test using the configuration
settings.
To load a test configuration
1 Select System Settings from the Main Menu, and then File Management.
2 Select Load Setup.
3 Scroll to the desired file name to load, and then press OK.
The test configuration is loaded.
NOTE:
If you change a setting, it is not automatically saved. You must either save the configuration
again and overwrite the previous settings, or create a new configuration.
NOTE:
Configurations cannot be loaded while a test is running. Load the configuration before testing.