User's Manual

Chapter 2 Instrument Settings
Specifying the volume level
SmartClass TPS User’s Guide
28 22035456, Rev 001 May 2014
To change the repeat rate
1 Select System Settings from the Main Menu.
2 Select Hardware Settings, and then Keypad Setup.
3 Select Auto Repeat Rate.
4 Change the level using the arrow keys, followed by the OK key.
The repeat rate is set.
Specifying the volume level
The Volume Setup menu allows you to adjust the handset volume.
To specify the volume level
1 Select System Settings from the Main Menu.
2 Select Hardware Settings, and then Volume Setup.
3 Select Handset Volume to specify the volume played through the built-in speaker.
The volume level is set.
Specifying international settings
The International Settings menu allows you to change the language of the user interface and
specify the measurement units.
To specify international settings
1 Select System Settings from the Main Menu.
2 Select Administration, and then International Settings.
3 Select the setting you wish to change:
– Language–changes the language of the user interface.
– Country–automatically sets the units based on the country.
The countries available will change depending on the language. For example, if you change
the language to Français, countries such as France and Canada are listed and there will be
no English speaking countries listed (for example, United Kingdom and Australia). The only
exception is English; all countries are listed when English is selected.
Other changes that happen automatically based on country include:
the cable pair names (from Tip, Ring, Ground to A, B, and E) and the technical assistance
phone number.
– Units–changes the measurement units (metric or imperial).
The international settings are specified.