User's Manual

Chapter 2 Instrument Settings
Adjusting the screen settings
SmartClass TPS User’s Guide
May 2014 22035456, Rev 001 27
2 Select Hardware Settings, and then Power Management.
The Power Setup menu appears, showing the battery level and the current power off delay.
3 Select Power Off Delay to set the power off delay.
This is the amount of time to wait (in minutes) after a keypress or no line activity before power
down.
The auto power down settings are specified.
Adjusting the screen settings
The Screen Settings menu allows you to adjust contrast and brightness.
To adjust the screen settings
1 Select System Settings from the Main Menu.
2 Select Hardware Settings, and then Screen Setup.
3 To change the screen for better viewing outdoors, select Outdoor Screen Mode.
4 Select the setting you wish to adjust: Contrast, Brightness, or Backlight.
5 Change the level using the up or down arrow key, followed by the OK key.
6 Optional. To make more precise adjustments, select Show More, and then select Red
Contrast, Blue Contrast, Red Brightness, or Blue Brightness.
The screen settings are adjusted.
Changing keypad setup
Using the Keypad menu, you can set the repeat delay and repeat rate.
Setting the repeat delay
The following procedure describes how to set the repeat delay. This setting defines the time to wait
after a key is held down until it begins to repeat. You can set the delay from 0.5 up to 10 seconds,
in 0.1 second increments.
To change the repeat delay
1 Select System Settings from the Main Menu.
2 Select Hardware Settings, and then Keypad Setup.
3 Select Auto Repeat Delay.
4 Change the level using the arrow keys, followed by the OK key.
The repeat delay is set.
Setting the repeat rate
The following procedure describes how to set the repeat rate. This setting defines how many times
the character will be repeated per second.