User's Manual

Chapter 1 Getting Started
Exploring the connector panel
SmartClass TPS User’s Guide
May 2014 22035456, Rev 001 11
Exploring the connector panel
The SmartClass Triple Play Services connector panel is used to connect to the line under test.
Figure 2 shows the connector panel.
The connector panel varies slightly depending on the configuration. The following paragraphs
describe each of the connectors on the right-side connector panel.
DSL connector
Use the 8-pin modular DSL jack when connecting to DSL circuits.
POTS connector
Use the POTS connector when placing or receiving POTS calls.
USB host connector
Use the USB host connector (USB 2.0) for saving results and configurations, or for firmware
updates.
Figure 2 SmartClass Triple Play Services connector panel
Ethernet connector
USB 2.0 connector
DSL line connector
POTS connector
CAUTION: FIRE HAZARD
To reduce the risk of fire, use only 26 AWG / 0.6mm or larger telecommunications line cord
between the DSL jack and the wall.