User's Manual

Chapter 1 Getting Started
Exploring the front panel
SmartClass TPS User’s Guide
10 22035456, Rev 001 May 2014
The available menus vary depending on the layout of the active menu when you press the Utility
key. Items 1 through 6 are always available. Items 7 and 8 are only available on list menus (tile
menus cannot be customized). For more detail on menus and layouts, see “Navigating the user
interface” on page 13.
Power key
Use the power key to turn the unit power on or off. Press and hold for 2 seconds to turn on.
Press to turn off, and then OK to confirm.
System Setup – a shortcut to the main System Setup menu. For more information on
this menu, see “Instrument Settings” on page 19).
Capture screen shot – saves the screen as a .png file.
(NOTE: The Utility menu itself cannot be captured this way. To capture the Utility
menu, remotely access the unit and capture it using the PrintScreen (PrtScn) key on
the PC.)
Report Settings – specify the filename, file format, report header information, and
other details related to the report.
Packet Capture – Shortcut to the Packet Capture menu, used to capture network
packets to a file on the SmartClass or to a file on a USB drive.
Outdoor Mode – changes the screen’s settings for better viewing outdoors.
Save To Job – launches the Save Test Result menu, allowing the results to be saved
to a specific job or saved to a file.
See “Saving results” on page 120.)
Menu Settings – customize the user interface. (For example, increase font size, move
menu item up or down in the list, and so on. See “Customizing the user interface” on
page 17.)