User's Manual

Chapter 17 StrataSync
Synchronizing to the StrataSync server
SmartClass TPS User’s Guide
May 2014 22035456, Rev 001 143
If not, from the StrataSync main menu, select Network and then Select Connect With and
specify the access technology through which the SmartClass TPS will be connected to the
network.
– Ethernet
–DSL
–Wi-Fi
3 Depending on the access technology specified in the step above, specify the interface to use
for the connection:
For Ethernet, select Network Setup to do the configuration. Refer to “Specifying the network
setup” on page 42 for the definitions of the
parameters.
For DSL, select DSL Setup to do the DSL configuration. Refer to “Specifying DSL settings” on
page 52 for the definitions of the parameters. Next, select DSL Network Setup to do the
network configuration. Refer to “Specifying the modem operation” on page 50, “Specifying
network settings” on page 54, and “Specifying WAN settings” on page 54 for the definitions of
the parameters.
For Wi-Fi, select Wi-Fi Network Setup to do the configuration. SSID is the public name of the
wireless network. Refer to “Specifying the network setup” on page 42 for the definitions of the
rest parameters.
4 From the StrataSync main menu, select Operation and then specify additional connection and
server settings.
Setting Description
Connection Type Specify how to connect to the server.
– Lookup – Use an intermediate server that will automati-
cally identify (“lookup”) the specific StrataSync server to
be addressed. The lookup server connection type is typi-
cally used when there are multiple StrataSync servers in
the user’s corporate footprint.)
– Direct – Use a direct reference to a specific StrataSync
server)
NOTE: The SmartClass TPS uses HTTPS (secure HTTP) to
connect to the server.
Server Method Specify how to refer to the server (this applies for both con-
nection types)
– Address Server by IP (192.168.0.1)
– Address Server by Name (myServer)
Server IP/Lookup Server IP, or
Server Name/Lookup Server Name
Enter the server IP/lookup server IP or the server name/
lookup server name on demand.
Server Port/Lookup Server Port Enter the server port number.
Proxy URL Enter the proxy URL. You can leave it blank - as by default
and not using any proxy.