User's Manual

Chapter 16 Test Results
VoIP results
SmartClass TPS User’s Guide
132 22035456, Rev 001 May 2014
Network Map
This category shows the layout of the network. The SmartID connected to the <product name> is
on the left and the home network cascades to the right. Use the up and down arrow keys to select
different SmartIDs on the map. Press OK to see details of a particular segment.
Sweep Data
This category shows a graph of the frequency sweep. Use the # key to reverse the direction.
VoIP results
The following section describes the results available in VoIP mode. To view the different categories
of statistics, use either the left and right arrows, or press the number for the desired result category.
Call Information results
Table 37 describes the Call Information results.
Throughput
Table 37 describes the Throughput results.
Audio Delay
Table 37 describes the Audio Delay results.
Table 36 Call Info results
Result Definition
Call Duration Length of time for the current call. If the call duration continues beyond
59:59 (meaning, is more than an hour), the display changes from mm:ss to
hh::mm (note the change from : to :: ).
Far End Information The IP address, ID Name, Alias, and Connect method for the incoming call.
Audio Parameters The receive and transmit codec being used, whether RTCP is being used for
the Audio or Video path, and whether silence suppression is enabled.
Table 37 Throughput results
Result Definition
Local Audio Bytes Total number of bytes transmitted (TX) or received (RX)
Local Audio Packets Total number of packets transmitted (TX), received (RX), lost, or out of
sequence (OOS).
Table 38 Audio Delay results
Result Definition
Incoming Audio Codec The audio codec used for the incoming call