User's Manual

Chapter 16 Test Results
SmartID results
SmartClass TPS User’s Guide
May 2014 22035456, Rev 001 131
SmartID results
The following section paragraphs describes the results available in SmartID tests.
Test Summary
This category provides an overview of the results, including basic pass/fail indications of the links
between the SmartIDs. Use the arrow keys to navigate and highlight a section. The details for that
section appear. If you navigate to a section/link that failed, the results on the left update and you
can see which measurement failed.
Detailed View
This category shows detail of the selected section/link of the network between two SmartIDs. Use
the # key to reverse the direction (change the focus from the near end of the cable to the far end).
Rate, Mod Mbps This is the current data rate, and baud/constellation of the
specific link.
Mbps, MBaud/bits
per symbol
0-112, 2-24/2-10
PER The Packet Error Rate on the specific link. Rate x.xxe+yy 0.00e0 - 1.00e0
SNR This is the Signal to Noise Ratio of the specific link. dB
Receive and Transmit Results
bytes The number of total (good and bad) transmitted or
received bytes
Bytes
packets The number of total (good and bad) transmitted or
received packets.
Packets
bcast The number of transmitted or received broadcast packets. Packets
mcast The number of transmitted or received multicast packets. Packets
dropped The number of transmitted or received packets dropped
due to lack of resources.
Packets
crc The number of received packets that have had an invalid
checksum.
(NOTE: There is no count for transmitted packets)
Packets
Protocol Messages
ctrl_log_req The number of control requests from the local host (CERT
protocol.)
ctrl_log_rec The number of control replies to the local host (CERT pro-
tocol.)
ctrl_rem_req The number of control requests from a remote host
(CERT protocol.)
ctrl_rem_rec The number of control replies to a remote host (CERT
protocol.)
Table 35 HPNA results (Continued)
Results Description Units Range/Values