User's Manual

Chapter 16 Test Results
Wi-Fi results
SmartClass TPS User’s Guide
May 2014 22035456, Rev 001 129
Traceroute results
Table 32 describes the trace route results.
Wi-Fi results
The following section describes the results available in Wi-Fi mode.
Status
Table 37 describes the status results. The status may be included on the Access Point Status menu
or the End Point Status menu.
Redirect count The number of times the client was redirected.
HTTP Code HTTP status code message
Header Size Number of bytes in the header
Request Size Number of bytes in the request message
Table 32 Trace route results
Result Definition
State Current state of the trace
Number of hops The number of points crossed from the source to the destination
Table 31 File Transfer results (Continued)
Result Description
Table 33 Status
Result Definition
Status Indicates the link status.
Scanning – Scanning for the SSID configured in setup
Associating – associating to a BSS
Associated – Associated to a BSS. However, the link is not fully up yet.
WPA Handshake – Completing the WPA handshake to set up encryption
Link up – Link is fully up.
SSID The Wi-Fi network ID that you are connected to.
BSSID The access point MAC address.
Signal Strength The strength of the signal, in dBm.
Protocol The Wi-Fi protocol in use (such as IEEE 802.11bg).
Channel The 802.11b/g channel the particular BSS is operating in.
Encryption Type The type of encryption (WPA/WEP)
Maximum BW The maximum bandwidth available on the network.
Network Status Status of the data network.