User's Manual

Chapter 11 VoIP Testing
Connecting to the line
SmartClass TPS User’s Guide
May 2014 22035456, Rev 001 91
Connecting to the line
After specifying the test settings, you can connect to the line. The procedure is different depending
on the access interface.
For Ethernet connections, connect as described in “Connecting to the line” on page 44.
For DSL connections, connect as described in “Connecting to the line” on page 57.
Placing and receiving calls
After specifying test settings and connecting to the line, you are ready to place and receive calls.
By placing and receiving calls you can do the following:
If you can successfully register with the Gateway (or Call Agent/TPS/Proxy/etc.) you have veri-
fied the provisioning.
If you can successfully place and receive calls from internal and external networks, you have
verified connectivity.
During an active call, you can view statistics such as MOS, Loss, and Jitter, to measure the call
quality.
Placing a call
The following procedure describes how to place a VoIP call.
To place a VoIP call
1 From the main VoIP menu, select VoIP Call.
The VoIP Call menu appears.
2 Select Number to Call.
The last number dialed appears.
To enter a different number, use the keypad. To backspace, use the down arrow key.
If the gatekeeper mode is None, enter the IP to Call also.
3 Select Handset Volume, and then use the arrow keys to adjust the volume.
4 Use the # key to Dial.
The unit to goes off hook and places the call.
The call status will update at the bottom of the screen.