User's Manual

Chapter 11 VoIP Testing
About VoIP
SmartClass TPS User’s Guide
86 22035456, Rev 001 May 2014
About VoIP
Using the optional VoIP testing features, you can emulate a VoIP phone to place and receive VoIP
calls.
You can expand your testing capability by purchasing additional VoIP testing options. The options
available for purchase are as follows:
For additional information about SmartClass Triple Play Services options and services, contact
your local JDSU representative or contact JDSU through the company web site, www.jdsu.com.
To access the VoIP application
– Select an interface (Ethernet TE, Wi-Fi, DSL-Bridge, or DSL-Modem/Router), and then select
VoIP.
The VoIP phone test involves the following steps:
– Specifying test settings
– Connecting to the line
– Placing and receiving calls
Specifying test settings
Before you begin testing, make sure that the SmartClass Triple Play Services settings match the
settings of the phone you are emulating.
To specify test settings
1 From the VoIP menu, select VoIP Setup.
Table 15 VoIP testing options
Option Description Order Number
VoIP VoIP application, including SIP, H.323, and MGCP signaling SCTP-VoIP
MOS Mean Opinion Score (MOS) option (requires VoIP option) SCTP-MOS
SCCP Cisco SCCP call control (requires VoIP option) SCTP-SCCP
NOTE:
VoIP is only available in IPv4 modes (not available in IPv6).
TIP:
Test configurations can be stored for easy recall and use (see “Managing test configurations” on
page 29).