Specifications

REGULATORY COMPLIANCE and NOTICES

This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions:

FCC Notice

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved in writing by the manufacturer could void the user’s authority to operate

the equipment.

CAUTION: Shielded I/O cables must be used and all covers must be in place when operating this equipment.

Canadian Department of Communications compliance statement:

ROHS Compliant Notice (Restriction of Hazardous Substances)

This digital apparatus does not exceed the Class B

limits for radio noise emissions from digital apparatus as set out in the Radio Interference Regulation of the Canadian

Department of Communications.

This product and its components are in compliance with Directive 2002/95/EC of the European Parliament.

REACH Compliant Notice

This product and its components are in compliance with EU Directive 1907/2006/EC.

WEEE Notice (Waste Electrical and Electronic Equipment)

ViaSat has marked this product with the WEEE symbol as a convenience to its customers for environmental responsibility per

European Union Directive 2002/96/EC. This product shall be collected and disposed of in accordance with national and local

laws. Waste electrical and electronic products must not be disposed of with household waste. For information on proper disposal,

contact your equipment distributor or service provider.

If additional information is required you may send correspondence to: Compliance-ProductEnvironmental@viasat.com

TRADEMARK NOTICE

SurfBeam

, the SurfBeam

logo, ViaSat and the ViaSat logo are trademarks or registered trademarks of ViaSat, Inc. in the U.S.

and/or other countries. Other product names included in this document are trademarks of their respective owners.

DOCUMENTATION NOTICE

The information, specifications, and features contained in this document are subject to change without notice and should not be construed as a

commitment by ViaSat, Inc.

ViaSat, Inc. assumes no responsibility for any errors that may appear in this document nor does it make an expressed or implied

warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for

a particular purpose. ViaSat, Inc. shall not be liable for incidental or consequential damages in conjunction with, or arising out of the

furnishing, performance, or use of this document or the product it describes.