Specifications

SurfBeam
®
2 Satellite Modem Outdoor Unit (ODU)
Installation Guide
Rev. 001 1104460 2-13
Figure 2-12 Mounting the Boom Arms.
Step 8: Elliptical Dish Installation
Fasten the Elliptical Dish to Antenna Back Bracket using five M8 x 20mm Carriage Bolts
inserted through the front of the Dish and through the five tabs located on the rim of the Antenna
Back Bracket. First, support the dish using a M8 x 20mm carriage bolt that has been fastened in
the upper hole of the dish (Figure Figure 2-13). Let the slot in the antenna back bracket support
the weight of the dish. Then insert the rest of the carriage bolts and secure them with serrated
nuts. Make sure that the square shoulders on the carriage bolts are seated in the square holes in
the Dish. Secure the Dish to the Antenna Back Bracket using a M8 Serrated Flange Nut on each
carriage bolt and tighten with a 13mm (or 1/2") wrench (Figure 2-14).
Note: Depending on installation situation, receiver dish might be attached prior to clamping to
pole, or afterwards.