Specifications

SurfBeam
®
2 Satellite Modem Outdoor Unit (ODU)
Installation Guide
2-12 1104460 Rev. 001
Step 6: Install Antenna onto Suitable Pole
With the antenna dish not yet installed, position the Antenna onto a suitable Pole as shown in
Figure 2-10. Rotate each Pole Clamp to engage the slotted end of the Clamp with the other side
of the U-Bolt as shown in Figure 2-10.
Hand-tighten each of the four M8 Serrated Nuts to bring the two Pole Clamps into contact with
the Pole (as shown in Figure 2-11), then tighten the four nuts with a 13mm (or 1/2") wrench.
Figure 2-11. Tightening the Clamps.
Step 7: Attaching the Boom Arms
Slide the Boom Arms into the slots at the bottom of the Antenna Back Bracket, aligning the
screw holes. To fasten the Boom arm to the Antenna Back Bracket, insert one M8 x 20mm Hex
Head Bolt through one M8 Washer and into each of the four screw holes in the slot and tighten
with a 13mm (or 1/2") wrench (Figure 2-4).