Specifications

SurfBeam
®
2 Satellite Modem Outdoor Unit (ODU)
Installation Guide
2-2 1104460 Rev. 001
Step 2: Fasten Antenna Back Bracket to Elevation Plate
Construct the Elevation, Azimuth, and Skew Adjustment Assembly by fastening the Skew Plate
to the front of the Elevation Bracket, through the Antenna Back Bracket.
Ensure that you align the A arrows. Pass four M8 x 20mm Carriage Bolts through the skew
plate, then the Antenna Back Bracket, and, finally, through the front of the Elevation Bracket.
Secure the Skew Plate using a M8 Washer, M8 Spring Washer, and a M8 Hex Nut on each
Carriage Bolt, as in (Figure 2-2).
Set the skew to 90 degrees, as shown in Figure 2-3. Tighten hardware with a 13mm (or 1/2")
wrench.