User manual

Programme Zapping option
In a BeeLINK environment the buttonsW and Rare being used for programme
stepping and to manoeuvre up and down in an on screen menu.
This is the basic OneRemote layout and compatible with other OneRemote controllers.
Some people prefer the programme zapping buttons on the up and down buttons. The
programme zapping option, make it possible to change the function of these buttons.
If the user would give it a fair chance, trying out the OneRemote layout, it is not likely
that he would make use of this option. The OneRemote layout adds much perspective to
many OSD menus on many devices, and makes sense once fully understood. But we are
up against habits, which we all wants to hang on to, so...
Option Function
090
W and Rare used for programme zapping.
091 D and Fare used for programme zapping. Factory setting.
An option programming sequence is initiated by pressing the little red switch on the BeeLINK2 controller, until
its LED starts flashing. Hereafter the 3 digit option code must be entered with the B&O remote control.
Menu button option
If the device is used in a setup that includes a Bang & Olufsen TV, sometimes the use of
the
m button gives a conflict.
Some Bang & Olufsen TV act on the
m and enters its own TV On Screen Menu
regardless of which source it is set to.
In these setups the Menu button must be disabled on the BeeLINK controllers. Instead of
using the Menu button to access the devices ‘Menu’, use the alternative menu operation
o5.
Option Function
080 Menu button blocked. Use alternative menu operation
081 Menu button enabled.
An option programming sequence is initiated by pressing the little red switch on the BeeLINK2 controller, until
its LED starts flashing. Hereafter the 3 digit option code must be entered with the B&O remote control.