User guide

2
Using your Viasat box
Your set-top box has been manufactured to meet international safety standards, but you must take
care if you want to obtain the best results and operate it safely.
It is important that you read this booklet completely, especially the safety instructions below. If you
have any doubts about the installation, operation or safety of your set-top box, please consult your dealer .
WARNING!
Remember that contact with 230 V AC mains can be lethal or can cause a severe
electric shock. To avoid this risk:
Never remove the top cover from your set-top box. There are no user-
serviceable parts inside it, but there are some high-voltage live parts.
Make sure that all electrical connections are properly made.
Do not connect any of your equipment (set-top box, TV, video recorder etc.) to
the mains supply until you have properly connected all the other leads.
Disconnect your set-top box from the mains supply (by disconnecting its mains
lead from the mains wall socket) before you disconnect any other equipment
from its rear panel.
Never push anything into the holes, slots or other openings of the set-top box
case (except a smart card into its correct slot).
CAUTION!
✔ In order to ensure a free flow of air around the set-top box, allow at least 5cm of space above
and around the set-top box.
✘ Never stand your set-top box on soft furnishings or carpets. Do not cover any ventilation slots.
✘ Do not place your set-top box in an unventilated cabinet or on top of a unit which emits heat
(e.g. a TV or VCR).
✘ Do not place your set-top box in a cabinet with more than one other piece of audio/video
equipment, for example, VCR or DVD.
✘ Do not use or store your set-top box in hot, cold, damp or dusty places.
✘ Do not put anything on your set-top box which might drip or spill into it. Never stand objects
filled with liquids, such as vases, on top of your set-top box.
✘ Never place naked flame sources, such as lighted candles, on top of your set-top box.
✘ To avoid possible damage to the internal hard disk, do not pick up or otherwise move your set-
top box while it is connected to the mains supply. If you want to move your set-top box, first
disconnect it, then wait at least 30 seconds before continuing.
For your safety