20011 - Dual 280C Onboard Air System (Black on Silver) 20013 – Dual 380C Onboard Air System (Chrome) 20014 – Dual 380C Onboard Air System (Stealth Black) 20015 – Dual 400C Onboard Air System (Chrome) 20016 – Dual 400C Onboard Air System (Stealth Black) 20017 – Dual 450C Onboard Air System (Chrome) 20019 – Dual 444C Onboard Air System (Chrome) 20020 – Dual 444C Onboard Air System (Stealth Black) *PARTS INCLUDED IN THE PRODUCT PHOTO MAY VARY.
DUAL ONBOARD AIR SYSTEM Thank you for purchasing this complete, self-contained onboard air system. Contained in one package, you’ll find everything you’ll need to install a high performance, onboard air source for your vehicle. Please follow these instructions to install your new system. OBA Components: (P/N 20011) 1 - 2.5 Gallon, 6 port VIAIR Air Tank (Max. 150 PSI), 2 - 280C Black on Silver VIAIR compressors (P/N 20013) 1 - 2.5 Gallon, 6 port VIAIR Air Tank (Max.
Coil Hose with Couplers: Pressure Switch & Relays: Y AA Z Pressure Switch REDUCER Drain Cock 86 Fused 12-Volt 87 30 85 To Ground RELAY WIRING SCHEMATIC Y. CC DD Compression Fitting BB EE FF Leader Hose From Compressor #2 REDUCER Accessories: BB. 1/8” BSP F to 1/4” NPT M Adaptors (for air locker use) (2pcs) CC. T-Fitting (1/4” M x 1/4” F x 1/4” F NPT (1pc) DD. 1/4” M NPT Plug (for regulator port block-off) (1pc) EE. 1/4” NPT M Compressor Fitting for 1/4”Air Line (1pc) FF.
DUAL ONBOARD AIR SYSTEM AIR TANK & PLUMBING The tank comes with six 1/4” NPT port openings to allow installation in many configurations on your vehicle. P/N 20011 To ensure safe and trouble-free use of your air tank, we strongly recommend that you install the supplied drain DUAL PLUMBING DIAGRAM cock and a safety pressure relief valve.
DUAL ONBOARD AIR SYSTEM AIR TANK & PLUMBING (CONT’D) Mounting the Tank: We have included 6 pieces of rubber bushings in your tank mounting hardware. You have the option of using two layers of rubber bushings on one of your tank legs to slightly tilt tank toward the drain cock port to improve drainage properties. Use the provided longer bolts, and corresponding washers, lock washers and nuts to mount the tank to a suitable chassis or other place on your vehicle.
DUAL ONBOARD AIR SYSTEM DUAL AIR COMPRESSOR INSTALLATION (CONT’D) Guidelines for Selecting Mounting Location: The selection of proper mounting location for your air compressor will help ensure a long and trouble free compressor service life. Please pay close attention to the following: - Select a FLAT, UPRIGHT & SECURE LOCATION where the compressor can be mounted.
DUAL ONBOARD AIR SYSTEM OPERATING INSTRUCTIONS IMPORTANT: The compressors have a maximum working pressure of 150 PSI (P/Ns 20011, 20015, 20016 & 20017) or 200 PSI (P/Ns 20013, 20014, 20019 & 20020). Always operate the compressor at or below the MAXIMUM PRESSURE RATING of the compressor. Operation exceeding maximum pressure ratings and or duty cycle will result in damage to air compressor. 1. Your air compressor is equipped with an AUTOMATIC THERMAL OVERLOAD PROTECTOR.
DUAL ONBOARD AIR SYSTEM DASH PANEL GAUGE INSTALLATION Your VIAIR Onboard Air System comes complete with a Dash Panel Gauge to monitor the pressure of your VIAIR air tank. Additionally, the Dash Panel Gauge has an ON/OFF switch preinstalled that will allow you to turn the system off by cutting power to the pressure switch with relay that you have already installed.
DUAL ONBOARD AIR SYSTEM DASH PANEL GAUGE INSTALLATION (CONT’D) 7. Connect to Power Source: Before connecting the power wire to a power source, check to make sure that the ON/OFF switch on the dash panel gauge is in the OFF position. Connect the ring terminal of the power wire to power source. (This is the wire described in Step 4, which is connected to the ON/OFF switch of the dash panel gauge.) 8. Testing Your Onboard Air System: Your Onboard Air System installation is now complete.
DUAL ONBOARD AIR SYSTEM TIRE INFLATION GUN OPERATING INSTRUCTIONS Your Onboard Air System also comes with a Tire Inflation Gun for airing up tires and adding compressed air to any inflatable items with a valve stem. 1. Using the Tire Inflation Gun: Use a 1/4“ Quick Connect Coupler, connect the Tire Inflation Gun to an air hose and connect to a tire valve stem or similar inflation collar by securing the folding lever on the Inflation Gun air chuck. 2.
DUAL ONBOARD AIR SYSTEM TROUBLESHOOTING GUIDE: PROBLEM POSSIBLE CAUSE(S) CORRECTIVE ACTION Tank pressure drops when compressor(s) shut off 1. Loose drain cock 2. Check valve leaking 3. Loose connections 1. Tighten drain cock 2. Replace check valve or compressor(s) 3. Check all connections with soap and water solution and tighten Compressor runs continuously and air flow lower than normal 1. Excessive air usage 2. Loose connections 3. Worn piston ring or inlet valve. 4. Clogged air filter element 1.
DUAL ONBOARD AIR SYSTEM COMPRESSOR APPLICATION GUIDE To ensure that you get the highest level of satisfaction from your compressor performance, refer to information below: VIAIR COMPRESSOR REFERENCE CHART COMPRESSOR SERIES DUTY CYCLE (100 PSI @ 72°F) 090 SERIES 9% 092 SERIES 9% 095 SERIES 9% 097 SERIES 10% 098 SERIES 10% 100 SERIES 15% 250 IG SERIES 100% 275 SERIES 25% 280 SERIES 30% 325 SERIES 33% 330 IG SERIES 100% 350 SERIES 100% 380 SERIES 100% *55% 400 SERIES 33% 420 SERIES 33% 444 SERIES 100% *50
DUAL ONBOARD AIR SYSTEM AMERICAN WIRE GAUGE GUIDE 12-VOLT: Amp Draw Length of wire from battery to compressor (in feet) 5 10 15 20 25 30 40 50 60 5 16 16 16 14 14 12 12 10 10 10 16 14 12 10 10 10 8 6 6 15 16 12 10 10 8 8 6 6 4 20 14 10 10 8 6 6 6 4 4 Wiring Diagram - Figure 3: (Fuse not included) COMPRESSOR WIRING DIAGRAM To Lamp Circuit Dash Panel To Keyed Power Source 12V 40A Relay 87 30 85 86 12V 40A Relay 87 30 85 86 15 Edelman Irvine, CA 92618 949-585-0011 www.viaircorp.
DUAL ONBOARD AIR SYSTEM SPECIFICATIONS • Part No. 20011 / 280C Dual OBA System Motor Voltage: Combined Max. Current Consumption: Motor Type: Horsepower: Max. Working Pressure: Max. Duty Cycle (@ 72°F & 100 PSI): Minutes On/Off (@ 72°F & 100 PSI): Max. Restart Pressure: Max. Ambient Temperature: Min. Ambient Temperature: Auto. Reset Thermal Protection: 12 Volts 33 Amps Permanent Magnetic 1/4 150 PSI 30% 18 min ON/42 min OFF 150 PSI 158°F -40°F Yes • Part No.
DUAL ONBOARD AIR SYSTEM SPECIFICATIONS • Part No. 20019 / 444C Dual OBA System • Part No. 20020 / 444C Dual OBA System - Stealth Black Motor Voltage: Combined Max. Current Consumption: Motor Type: Horsepower: Max. Working Pressure: Max. Duty Cycle (@ 72°F & 100 PSI): Minutes On/Off (@ 72°F & 100 PSI): Max. Restart Pressure: Max. Ambient Temperature: Min. Ambient Temperature: Auto.
DUAL ONBOARD AIR SYSTEM LIMITED WARRANTY: VIAIR Corporation warrants this product, when properly installed and under normal conditions of use, to be free from defects in workmanship and materials for a period of one year from its original date of purchase. To receive warranty service or repair, please contact VIAIR Corporation. Returns should be made within one year of the date of purchase, after a Return Goods Authorization (RGA) number has been assigned by VIAIR Corporation.