HORNBLASTERS Bandit 127VX Installation Manual
HornBlasters Support Line: +1 (877) 209-8179 Fax Line: +1 (813) 783-2407 support@hornblasters.com www.hornblasters.com/support Bandit 127VX Train Horn Kit Installation Guide Before Getting Started Read over the entire instruction guide before you begin your installation. Kit Contents: HornBlasters Bandit Horn ViAir 20003 On Board -Air Source Unit Fittings, Air Line, Wiring Kit IMPORTANT: This complete train horn kit uses 12 volt DC components. Only install this kit with a 12 volt DC power source.
Installing Your Train Horn Kit Planning Your Installation This is the most important step in your installation. Plan out the location of each component before starting your installation. Make sure you have enough air line and wire to install the system before beginning the installation. Make sure mounting locations are secure and void of debris. Try to keep the supply wire to the compressor as short as possible.
III. Installing Your Air Tubing & Air Valve Before cutting any air tubing make sure to double check your measurements. Compression fittings useferrules (olives) that should be used only once. When threading any fittings make sure to use Teflon tape or lock-tight to prevent air leaks.The air valve may be mounted in any directionbut it is preferred that it is mounted vertically with arrow pointing towards the horn.
Maintenance & Tips Disconnect electrical components and drain your air system before performing maintenance. General Air Horn System Maintenance Check your air horns for debris when appropriate and at least once a month and clean when necessary. Drain your air system at least once a month to remove any condensation buildup on the inside of your air tank. Make sure your air compressor is clean and free from debris at all times. Periodically change your two stage air filter on your compressor.
Photograph & Media Submission Guidelines Send in your installation photographs and any other media for a chance to be featured on our website! General Photograph Submission Guidelines Please submit clean, concise photographs. Make sure your subject is clearly visible and in focus. You may submit any digital image format either via email at media@hornblasters.com, or via digital media (CD, DVD, etc). Make sure to include some kind of personal information with your submission.
HORNBLASTERS.COM Bandit 1.5 Gallon Tank/Comp. Combo Installation Diagram Toggle Switch 12 Volt DC Ignition Source Run this wire to an ignition wire (this is a wire that is only powered when the key is turned to the on position). This will insure that the air compressor will not run when the car is turned off and drain your batteries. Inline fuse Air Source Load (Red) Ground (Black) Air Compressor 1/2” Air Line AIR TANK Power (Red) HORNBLASTERS Hornblasters, Inc.
