User manual

User Manual 20
3-1. Standard CMOS Features
The Standard Setup is used for the basic hardware system configuration. The
main function is for Data/Time and Hard Disk Drive settings.
․Video
Select the type of primary video subsystem.
<Choice: EGA / VGA, CGA 40, CGA 80, MONO>
․Halt On
Set the system’s response to specific boot errors.
<Choice: All Errors, No Errors, All, But Keyboard>
IDE Drives
Item Available Options:
IDE HDD Auto-Detection Press Enter
IDE Channel Auto
Access Mode Auto
The specifications of your drive must match with the drive table. The hard disk
will not work properly if you enter incorrect information in this category. Select
“Auto” whenever possible. If you select “Manual” make sure the information is
from your hard disk vendor or system manufacturer.
Item Available Options:
Date (mm:dd:yy)
Time (hh:mm:ss)
IDE Channel 0 Master:
Auto
IDE Channel 0 Slave :
Auto
IDE Channel 1 Master:
Auto
IDE Channel 1 Slave :
Auto
IDE Channel 2 Master :
Auto
IDE Channel 3 Master :
Auto
Video
EGA/VGA
Halt On
All , But Keyboard