User`s manual

Installation

Case Connector: FPANL

The FPANL pin header allows you to connect the power switch, reset switch,

power LED and the HDD LED.

Pin Signal Pin Signal

1 PW_LED 2 5V_P

3 PW_LED 4 HD_LED

5 GND 6 PW_BN

7 NC 8 GND

9 GND 10 RST_SW

11 -EXTSMI 12 GND

Power Switch (PW_BN), pin 6 & pin 8

Connect to a 2-pin power button switch. Pressing this button will turn the

system power on or off.

Reset Switch (RST_SW), pin 10 & pin 12

The reset switch is used to reboot the system rather than turning the power

ON/OFF. Avoid rebooting the system, if the HDD is still working. Connect

the reset switch from the system case to this pin.

Power LED (PW_LED), pin 1, pin 2, & pin 3

The LED will light when the system is on. If the system is in S1 (POS -

Power On Suspend) or S3 (STR - Suspend To RAM) state, the LED will blink.

HDD LED (HD_LED), pin 2 & pin 4

HDD LED shows the activity of a hard disk drive. Avoid turning the power

off when the HDD LED still has a lit. Connect the HDD LED from the system

case to this pin.

FPNL

212