User`s manual

BIOS Setup
3-21
ECP Mode Use DMA
The ECP mode has to use the DMA channel, so choose the onboard
parallel port with the ECP feature. After selecting it, the following mes-
sage will appear: “ECP Mode Use DMA.” At this time, the user can choose
between DMA channel 3 or 1.
PWRON After PWR-Fail
This setting specifies whether your system will reboot after a power fail-
ure or interrupts occurs. Available settins are:
Off Leaves the computer in the power off state.
On Reboots the computer.
Former-Sts Restores the system to the status before power failure or
interrupt occurs.
Game Port Address/Midi Port Address
This setting disables or assigns an address for the onboard game/midi
port.
Midi Port IRQ
This setting specifies an IRQ for the onboard midi port.
Init Display First
This setting specifies which VGA card is your primary graphics adapter. Set-
ting options: PCI Slot and AGP.
OnChip USB Controller
This setting allows you to activate the onchip USB controller. Setting options:
All Disabled, All Enabled, 1&2 USB Port, 2&3 USB Port, 1&3 USB Port, 1
USB Port, 2 USB Port, 3 USB Port.
USB Keyboard/Mouse Support
Set to Enabled if your need to use a USB keyboard/mouse in the operating
system that does not support or have any USB driver installed, such as DOS
and SCO Unix. Setting options: Disabled, Enabled.