User`s manual

Chapter 2
2-6
DDR Module Installation
You can install either single sided or double sided 184-pin DDR DIMM mod-
ules into DDR DIMM, depending on your requirements. Differing from SDR
DIMM, DDR DIMMs have only one notch on the center of the module. The
number of pins on either side of the breaks are also different. The memory
modules will only fit if placed in the correct orientation.
You can install DDR266 SDRAM modules in any of the following combinations:
Slot Memory Module Total Memory
Slot 1
(Bank 0 & Bank 1)
64M B, 128M B,
256MB, 512M B, 1GB
64M B~1GB
Slot 2
(Bank 2 & Bank 3)
64M B, 128M B,
256MB, 512M B, 1GB
64M B~1GB
Slot 3
(Bank 4 & Bank 5)
64M B, 128M B,
256MB, 512M B, 1GB
64M B~1GB
M aximum System Memory Supported
64M B~3GB
1. The DDR DIMM module has only one notch on the center.
2. Insert the DDR module vertically into the DDR DIMM slot. Make sure the
notch is correctly aligned.
3. The plastic clips at sides of the DIMM slot will automatically close shut.
Rear ViewRear View
Rear ViewRear View
Rear View
Front ViewFront View
Front ViewFront View
Front View
Volt