User`s manual

Chapter 2
2-6
DDR Module Installation Procedures
You can install either single sided or double sided 184-pin DDR DIMM
modules into DDR DIMM slots, depending on your requirements. As op-
posed to SDR DIMMs, DDR DIMMs have only one notch in the center of
module. The modules will only fit if placed in the correct position.
You can install memory modules in any of the following combinations:
Socket Memory Module Total Memory
Slot 1
(Bank 0 & Bank 1)
32MB, 64MB, 128MB,
256MB, 512MB, 1GB
32MB~1GB
Slot 2
(Bank 2 & Bank 3)
32MB, 64MB, 128MB,
256MB, 512MB, 1GB
32MB~1GB
Maximum System Memory Supported
32MB~2GB
1. The DDR DIMM module has only one notch in the center.
2. Insert the DDR module vertically into the DDR DIMM slot. Make sure the
notch is in the right position.
3. The plastic clips at sides of the DIMM slot will automatically close.
Volt
Front View Rear View