User`s manual

2
22
Hardware Installation
2.5 Jumper Settings for Wake-On-USB Keyboard
2-3 On: Enable - 5VSB
(default)
1-2 On: Disable - VCC
3
2
1
3
2
1
Wake-On-USB Keyboard for USB 1 and 2 - JP2
The Wake-On-USB Keyboard function allows you to use a USB
keyboard to wake up a system that is in the S3 (STR - Suspend To
RAM) state.
By default, this function is enabled, pins 2 and 3 set to On. Make
sure “USB Resume from S3” (“IRQ/Event Activity Detect” field) in
the Power Management Setup submenu of the BIOS is also
enabled.
Important:
If you are using the Wake-On-USB Keyboard function for 2 USB
ports, the 5VSB power source of your power supply must
support ≥ 1.5A.