User`s manual

BIOS Setup
35
First/Second/Third Boot Device
Set the boot device sequence as BIOS attempts to load the disk operating
system.
Floppy The system will boot from floppy drive.
LS120 The system will boot from LS-120 drive.
HDD-0 The system will boot from first HDD.
SCSI The system will boot from SCSI.
CD-ROM The system will boot from CD-ROM.
HDD-1 The system will boot from second HDD.
HDD-2 The system will boot from third HDD.
HDD-3 The system will boot from fourth HDD.
ZIP100 The system will boot from ATAPI ZIP drive.
USB-FDD The system will boot from USB floppy drive.
USB-ZIP The system will boot from USB ZIP drive.
USB-CDROM The system will boot from USB CDROM.
USB-HDD The system will boot from USB HDD.
LAN The system will boot from network drive.
Disabled Disable this sequence.
Boot Other Device
Enable the system to boot from alternate devices if the system fails to boot
from the First/Second/Third boot device. Settings:
Enabled and Disabled
Swap Floppy Drive
If the system has two floppy drives, choose Enabled to assign physical drive B
to logical drive A and vice versa. Settings:
Enabled and Disabled
Boot Up Floppy Seek
Set floppy seek during POST, BIOS will determine whether the floppy is 40 or
80 tracks. Settings:
Enabled and Disabled
Boot Up NumLock Status
Set the NumLock status when the system is powered on. On will turn key pad
into number keys, and
Off will turn key pad into arrow keys. Settings: On and Off
Typematic Rate Setting
When Enabled , you can set the Typematic Rate and Typematic Delay.
Settings:
Enabled and Disabled