User`s manual

3-10 Chapter 3
 DRAM Clock/Drive Control:
Click <Enter> key to enter its submenu:
Phoenix – AwardBIOS CMOS Setup Utility
DRAM Clock/Drive Control
Current FSB Frequency 166 MHz Item Help
Current DRAM Frequency 133 MHz
DRAM Clock [By SPD]
DRAM Timing Selectable [By SPD]
X - CAS Latency Time 2.5
X - Bank Interleave Disabled
X - Precharge to Act.(Trp) 4T
X - Act. To Precharge(Tras) 9T
X - Active to CMD(Trcd) 4T
X - Ref to Active(Trfc) 15T
X - Active to Active(Trrd) 2T
DRAM BUS Selection [Auto]
DRAM Command Rate [2T Command]
DDR DQS Input Delay [Auto]
X - DQS Input Delay Value 18/14(GrayCode)
DDR DQS Output Delay [Auto]
X - Ch. A DQS Output Delay 5E/71(GrayCode)
X - Ch. B DQS Output Delay 87/C4(GrayCode)
X - Ch. A MD Output Delay 8D/CB(GrayCode)
X - Ch. B MD Output Delay 64/56(GrayCode)
DQS/DQM/CS/CKE/Max Drive [Auto]
X - RxE0 Ch. A DQS Drive 75
X - RxE1 Ch. B DQS Drive 00
X - RxE2 Ch. A DQM Drive 65
X - RxE3 Ch. B DQM Drive 00
X - RxE4 Ch. A CS/CKE Drive 98
X - RxE5 Ch. A CS/CKE Drive 00
X - RxE8 MAA Drive A9
X - RxEA MAB Drive A9
DQS Input Delay [Auto]
X Rx7C DIMM0 00
X Rx7D DIMM1 00
X Rx7E DIMM2 00
X Rx7F DIMM3 00
Prefetch Controller [Enabled]
S2K series control [Auto]
X Rx8C S2K DICLK delay A0
X Rx8D S2K duty cycle adju 00
X Rx8E S2K duty cycle adju C0
X Rx8F S2K duty cycle adju 00
↑↓:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Current FSB Frequency:
This item will show you the current system front side bus speed.
Current DRAM Frequency:
This item will show you the current DRAM bus speed.
KW7 Series