Specifications

BIOS Setup
English
- 43 -
MB Intelligent Tweaker (M.I.T)
Frequency/Voltage Control
DRAM Timing
Auto By SPD BIOS will automatically setup the DRAM Timing by DRAM SPD data.
(Default value)
Manual This item allows user to set DRAM Timing Manually.
DRAM CAS Latency
1.5/2/2.5/3 Set DRAM CAS Latency time to 1.5/2/2.5/3(Default value:2.5).
Bank Interleave
This feature allows user to select the DRAM access method.
4Bank /2Bank /Disabled Set DRAM access method to 4Bank/2Bank/Disanled(Default value:4Bank)
Precharge to Active(Trp)
2T/3T/4T/5T Set Precharge to Active(Trp) to 2T/3T/4T/5T(Default value:3T)
Active to Precharge(Tras)
6T/7T/8T/9T Set Active to Precharge(Tras) to 6T/7T/8T/9T(Default value:6T)
Active to CMD(Trcd)
2T/3T/4T/5T Set Active to CMD(Trcd) to 2T/3T/4T/5T(Default value:3T)
RET to ACT/REF to REF(Trfc)
12T/13T/14T/15T Set RET to ACT/REF to REF(Trfc) to 12T/13T/14T/15T(Default Value:12T)
ACT(0) to ACT(1) (Trrd)
This feature allows user to select the ACT(0) to ACT(1) (Trrd), when any DRAM DIMM
installed.
2T/3T Set ACT(0) to ACT(1) (Trrd) to 2T/3T(Default Value:2T)
CPU Ratio Control
This option will not be shown or not be available if you are using a CPU with the locked ratio.
5X~22.5X,Normal It depends on CPU Clock Ratio.(Default Value:Normal)
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
MB Intelligent Tweaker (M.I.T)
DRAM Timing [Auto By SPD]
x DRAM CAS Latency 2.5
x Bank Interleave 4 Bank
x Precharge to Active (Trp) 3T
x Active to Precharge (Tras) 6T
x Active to CMD (Trcd) 3T
x RET to ACT/REF to REF (Trfc) 12T
x ACT(0) to ACT(1) (Trrd) 2T
CPU Ratio Control [Normal]
Spread Spectrum Modulated [Enabled]
CPU Host Clock Control [Disabled]
x CPU Host Frequency (MHz) 133
PCI / AGP Frequency (MHz) 33/66
DRAM Clock [By SPD]
CPU Voltage Control [Normal]
Normal CPU Vcore 1.600V
AGP Voltage Control [Auto]
DDR Voltage Control [Auto]
higf: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level}
Incorrect using these features may cause your system broken. For power End-User use only!