Specifications

- 6 -7VT600 1394 Motherboard
English
On-Board Sound y Realtek ALC655 CODEC
y Supports Jack Sensing function
y Line Out / 2 front speaker
y Line In / 2 rear speaker(by s/w switch)
y Mic In / center& subwoofer(by s/w switch)
y SPDIF Out /SPDIF In
y CD In / AUX In / Game port
On-Board USB 2.0 y Built in VIA VT8237 Chipset
On-Board SATA RAID * y Built in VT8237
(Note1)
y Supports Disk striping (RAID0) or DISK Mirroring (RAID1)
y Supports UDMA up to 150 MB/sec
y AIL UDMA and PIO Modes
y Up to 2 SATA Device
y ACPI and ATA/ATAPI6
On-Board LAN y RealTek RTL8101L
y 1 RJ45 port
On-Board IEEE1394 y VT6306
PS/2 Connector y PS/2 Keyboard interface and PS/2 Mouse interace
BIOS y Licensed Award BIOS
y Supports Dual BIOS /Q-Flash
Additional Features y PS/2 Keyboard power on by password,PS/2 Mouse power on
y External Modem wake up
y STR(Suspend-To-RAM)
y Wake on LAN (WOL)
y AC Recovery
y Poly fuse for keyboard over-current protection
y USB KB/Mouse wake up from S3
y Support Thermal shutdown function
y Supports @BIOS
y Supports EasyTune 4
Overclocking y Over Voltage (DDR/AGP/CPU) by BIOS
y Over Clock (DDR/AGP/CPU/PCI) by BIOS
Please set the CPU host frequency in accordance with your processor's specifications.
We don't recommend you to set the system bus frequency over the CPU's specification
because these specific bus frequencies are not the standard specifications for CPU,
chipset and most of the peripherals. Whether your system can run under these specific
bus frequencies properly will depend on your hardware configurations, including CPU,
Chipsets,SDRAM,Cards….etc.
'* ' If you want to find the detailed information for SATA RAID setup installation,
please download "VT8237_SATA_Manual.pdf" at "http:\\www.gigabyte.com.tw"
(Note 1) It is recommended to use SATA (1.5Gb/s) hard disks.