User`s manual

63
3
BIOS Setup
Ultra If you want the system to run at a speed faster
than “Turbo”, select this option. However, com-
patibility problems may occur with some
DRAMs. If you encounter any problems, set this
field to “By SPD” or “Manual”.
Manual This option allows you to manually select the
options in the “DRAM CAS Latency” to “Active
to CMD (Trcd)” fields. The system will run ac-
cording to the settings in these fields.
DRAM CAS Latency
This field is used to select the clock cycle of the SDRAM CAS
latency time. The option selected specifies the time before
SDRAM starts a read command after receiving it.
Bank Interleave
The options are Enabled and Disabled.
Precharge to Active (Trp)
The options are 2T, 3T, 4T and 5T.
Tras Non-DDR400/DDR400
The options are 5T/6T, 8T/12T, 6T/8T and 7T/10T.
Active to CMD (Trcd)
The options are 2T, 3T, 4T and 5T.
DRAM Burst Length
The options are 4 and 8.
DRAM Command Rate
The options are 1T Command and 2T Command.