User`s manual

39
2
Hardware Installation
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
Front Audio
The front audio connector (J1) allows you to connect to the
line-out and mic-in jacks that are at the front panel of your sys-
tem. Using this connector will disable the rear audio’s line-out
and mic-in functions.
Remove the jumper caps from pins 5-6 and pins 9-10 of J1 prior
to connecting the front audio cable connector. Make sure pin 1
of the cable connector is aligned with pin 1 of J1. If you are not
using this connector, make sure to replace the jumper caps back
to their original pin locations.
Driver Installation
Install the “Realtek Audio Drivers”. An audio software application
program will at the same time be installed into your system. This
program will allow you to configure 2-channel, 4-channel and 6-
channel audio modes as well as configure the audio effects. Refer
to chapter 4 for more information.