Setup guide

Using BIOS

Init Display First (PCI Slot)

Use this item to specify whether your graphics adapter is installed in one of the PCI slots or

is integrated on the motherboard.

Press <Esc> to return to the Integrated Peripherals screen.

Onboard Parallel Port (378/IRQ7)

This option is used to assign the I/O address and interrupt request (IRQ) for the onboard

parallel port.

Parallel Port Mode (ECP)

Enables you to set the data transfer protocol for your parallel port. There are four options:

SPP (Standard Parallel Port), EPP (Enhanced Parallel Port), ECP (Extended Capabilities

Port), and ECP+EPP.

SPP allows data output only. Extended Capabilities Port (ECP) and Enhanced Parallel Port

(EPP) are bi-directional modes, allowing both data input and output. ECP and EPP modes

are only supported with EPP- and ECP-aware peripherals.

ECP Mode Use DMA (3)

When the onboard parallel port is set tp ECP mode, the parallel port can use DMA3 or

DMA1.

Power Management Setup

This option lets you control system power management. The system has various power-

saving modes including powering down the hard disk, turning off the video, suspending to

RAM, and software power down that allows the system to be automatically resumed by

certain events.

The power-saving modes can be controlled by timeouts. If the system is inactive for a time,

the timeouts begin counting. If the inactivity continues so that the timeout period elapses,

the system enters a power-saving mode. If any item in the list of Reload Global Timer

Events is Enabled, then any activity on that item will reset the timeout counters to zero.

If the system is suspended or has been powered down by software, it can be resumed by a

wake up call that is generated by incoming traffic to a modem, a LAN card, a PCI card,

or a fixed alarm on the system realtime clock

Phoenix-AwardBIOS CMOS Setup Utility

Power Management Setup

Item Help

Menu Level

Power Management Option [User Define]

HDD Power Down [Disabled]

Suspend Mode [Disabled]

Video Off Option [Susp, Stby->Off]

Video Off Method [DPMS Support]

MODEM Use IRQ [3]

Soft-Off by PWRBTN [Instant-Off]

PWRON After PWR-Fail [Off]

IRQ/Event Activity Detect [Press Enter]

: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help

mnlk

F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults