User`s manual

BIOS Setup
3-9
First/Second/Third Boot Device
Set the boot device sequence as BIOS attempts to load the disk operating
system. The settings are:
Boot Other Device
Enable the system to boot from other devices if the system fails to boot from
the First/Second/Third boot device. Settings:
Enabled and Disabled
Boot Up NumLock Status
Set the NumLock status when the system is powered on. On will turn key
pad into number keys, and
Off will turn key pad into arrow keys. Settings: On
and
Off
Typematic Rate Setting
When Disabled, the following two items (Typematic Rate and Typematic
Delay) are irrelevant. Keystrokes repeat at a rate determined by the keyboard
controller in your system. When
Enabled, you can select a typematic rate and
typematic delay. Settings:
Enabled and Disabled
LS120 The system will boot from LS-120 drive.
HDD-0 The system will boot from first HDD.
SCSI The system will boot from SCSI.
CD-ROM The system will boot from CD-ROM.
HDD-1 The system will boot from second HDD.
HDD-2 The system will boot from third HDD.
HDD-3 The system will boot from fourth HDD.
ZIP100 The system will boot from ATAPI ZIP drive.
USB-FDD The system will boot from USB floppy drive.
USB-ZIP The system will boot from USB ZIP drive.
USB-CDROM The system will boot from USB CDROM.
USB-HDD The system will boot from USB HDD.
LAN The system will boot from network drive.
Disabled Disable this sequence.