User`s manual

Chapter 2
2-4
Memory Module Installation
The VIA EPIA-TC Mini-ITX Mainboard provides one SODIMM slot on the
bottom-side of the board. It uses 200-pin DDR266 memory modules.
DDR SDRAM Module Installation Procedures
1. Make sure the notch is on the proper side.
2. Insert the memory module into the slot at a 30 degree angle (30 degrees
from the board). You should feel it lightly snap into place.
3. Push the module up against the board and release your finger when the
clips lock the module.
Memory slot located on the
bottom-side of the board.