User`s manual

BIOS Setup
61
Onboard Parallel Mode
Set the parallel port mode. To operate the onboard parallel port as
Standard Parallel Port, choose Normal . To operate the onboard parallel port
in the EPP mode, choose EPP . By choosing ECP , the onboard parallel port
will operate in ECP mode. Choosing ECP + EPP will allow the onboard
parallel port to support both the ECP and EPP modes simultaneously.
Settings: [Normal, EPP, ECP, ECP + EPP]
ECP Mode Use DMA
ECP (Extended Capabilities Port) has two DMA channels that it can use. The
default channel is 3. However, some expansion cards may use channel 3 as
well. To solve this conflict, change the ECP channel to 1. Select a DMA
channel for the port.
Settings: [1, 3]
Parallel Port EPP Type
EPP (Enhanced Parallel Port) comes in two modes: 1.9 and 1.7. EPP 1.9 is
the newer version of the protocol and is backwards compatible with most
EPP devices. If your EPP device does not work with the EPP 1.9 setting, try
changing the setting to EPP 1.7.
Settings: [EPP 1.9, EPP 1.7]
Onboard FIR Select
Enables the onboard FIR.
Settings: [Enabled, Disabled]