User`s manual

Installation
13
MEMORY MODULE INSTALLATION
The VIA EPIA-MS Mini-ITX mainboard provides one 200-pin SODIMM slot for
DDR266 SDRAM memory modules and supports the memory size up to 1GB.
DDR SDRAM Module Installation Procedures
• Make sure the notch is on the proper side. The module will only fit
in the right orientation.
• Insert the memory module into the slot at a 30 degree angle (30
degrees from the board). It should lightly snap into place.
• Push the module up against the board until the golden finger of the
memory module is deeply inserted into the socket. The plastic clip
at each side of the SODIMM slot will lock the module.
Memory slot
located on
the bottom-
side of the
mainboard
Available DDR SDRAM Configurations
Refer to the table below for available DDR SDRAM configurations on the
mainboard.
Slot Module Size Total
SODIMM 64MB, 128MB, 256MB, 512MB, 1GB 64MB-1GB
Maximum supported system memory 64MB-1GB