User manual

51
First/Second/Third Boot Device
Set the boot device sequence as BIOS attempts to load the disk
operating system.
Settings Description
LS120 Boot from LS120
Hard Disk Boot from the HDD
CDROM Boot from CDROM
ZIP100 Boot from ZIP100
USB-FDD Boot from USB Floppy
USB-ZIP Boot from USB ZIP drive
USB-CDROM Boot from USB CDROM
Legacy LAN Boot from network drive
Disabled Disable the boot device sequence
Boot Other Device
Enables the system to boot from alternate devices if the system fails
to boot from the “First/Second/Third Boot Device” lists.
Settings Description
Disabled No alternate boot device allowed
Enabled Enable alternate boot device
Boot Up NumLock Status
Set the NumLock status when the system is powered on.
Settings Description
Off Forces keypad to behave as arrow keys
On Forces keypad to behave as 10-key
Typematic Rate Setting
Enable “Typematic Rate” function.
Settings: [Disabled, Enabled]
Typematic Rate (Chars/Sec)
This item sets the rate (characters/second) at which the system
retrieves a signal from a depressed key.
Settings: [6, 8, 10, 12, 15, 20, 24, 30]
Typematic Delay (Msec)
This item sets the delay between, when the key was first pressed
and when the system begins to repeat the signal from the
depressed key.
Settings: [250, 500, 750, 1000]