User`s manual
Table Of Contents
- Introduction
- Hardware Installation
- Award BIOS Setup Utility
- Supported Softwares
- System Error Message
- Troubleshooting
2
Hardware Installation
13
Pin 1
Notch
Key
Tab
Tab
1. Pull the tabs which are at the ends of the socket to the side.
2. Position the DIMM above the socket with the notches in the
module aligned with the keys on the socket.
3. Seat the module vertically into the socket. Make sure it is
completely seated. The tabs will hold the DIMM in place.
2.2.1 Installing the DIM Module
A DIM module simply snaps into a DIMM socket on the system
board. Pin 1 of the DIM module must correspond with Pin 1 of the
socket.