User`s manual

User will need to select the desired camera for recording or not recording.
After clicking Ok button, the system will then transmit the images to the
local system’s image section for display or record as preset.
9.5 Remote PTZ and Output Port Control Functions
After switching to the remote host, setting of the remote PTZ and Output
Control function are the same to the local site. Please refer to
Chapter7.2
PTZ control panel and Chapter7.3 Output Port Control for more detail.
Remote PTZ control panel only provide control function, not the setting
function.
9.6 Remote/Monitoring Setup Example
When using TCP/IP for remote monitoring (Includes LAN, Internet, etc),
communicate and transmission between hosts have to go through
ChateauServer. One of the hosts has to activate ChateauServer program
for this. This host does not need to install with VGuard cards.
 Setup Server (Listening Port: defaulted 40000)
1. Install Server software on a computer, this computer is better to
have a fixed IP address.
2. If the server is set on a real IP on internet (etc 211.172.12.34), If
the server’s IP is 211.172.12.34 and the communication port is
40000, All the network setting for all VGN Embedded DVR or
ChateauRT4 system address setting on the internet, the Server IP
will need to be 211.172.12.34.
3. If the server is set on a virtual IP on internet (etc 192.168.1.11), If
the server’s IP is 192.168.1.11 and the communication port is
40000, All the network setting for all VGN Embedded DVR or
ChateauRT4 system address setting under the same LAN, the
Server IP will need to be 192.168.1.11.
4. If server is set on a virtual IP under LAN (i.e. 192.168.1.11), but
also require for Internet uses, then you will require to do NAPT
(Network Address Port Translation) in your router to
correspondence. You can then able to connect to the computer with
83