User`s manual

User’s authorization is depending on the authorization setting for logging in
the host, not the remote site authorization. Please refer to
Chapter 3.5 User
for more detail.
After host panel had switch to remote host, only the
of the control
panel buttons are for remote host system setting. All other buttons are local
site host control button. And the remote host system setting is different to
the local site. Setting manual as below:
9.3.1 VGuard Board Setup
If the remote Chateau System is not in recording, you may change its
board settings during this period of time. If the remote system has
already activated recording function, this function then is not workable
9.3.2 Camera Setup
Except the enable and disable camera functions, all other functions
are changeable. Setup is same to the local site. (Please refer to
Chapter 6.2 Setup for receiving DVR remote warning for warning
setup.)
9.3.3 Unmask or mask detection area
Only the remote site is log in as System Administer will be able to
see, setup or delete the mask area. Click on the desired remote
camera, and then click the Unmask button
on the Camera Setup
Section to cancel all the detection areas. You can also set up a new
detection area; setup is the same to the local site. (Remote
Embedded DVR does not support this function)
9.3.4 Video Configuration
Click the Video Configuration
button on the Camera Setup
Section to change the remote video configuration as desired.
9.4 Remote recording and Remote function
After switching to remote host, click to pop up the dialog as below:
82